aquapetz.com

Today I will try to do this.

Rajiv, please share once you have tried your on it.

Rajivji, any progress?

aawnaik wrote:Rajivji, any progress?

Super busy upto 27th January. After that I will try.

Yesterday, I made DIY Twinstar Algae Inhibitor. The materal used is as under -

1. Aluminum Wire Mesh
2. Teflon Tape winder
3. Mobile Charger for power

Great stuff sir!
Do you have assembly pics step by step?

saikumar wrote:Great stuff sir!
Do you have assembly pics step by step?

+1

I also want step by step photographs.

Ups! That's a difficult job. Don't have pics but will try to explain.

here is the process I followed -

1. Teflon Tape Winder -

The wheel on which the tape is wound was cut to make 2 plastic disks. The inside diameter of the 2 disks was increased by cutting it with scissor.

2. Aluminum wire mesh was cut in round shape to match the size of the 2 disks (2 pieces of alumimum wire mesh disk) connected the electrical wire with the help of soldering rold. Two ends of wire to 2 pieces of wiremesh.

3. Now the challegne was to avoid the contact between the 2 wire mesh disks, so found out as old tennis racket (plastic) of my kids and cut the inside plastic squares so as to wor as a seperator beteen the 2 wire mesh disks.

4. The outer ring of the Teflon Tape Plastic was used to fix the parts as under -

a. made a whole in the out ring to insert the electric wire
b. bottom layer plastic disc
c. on top of it wiremesh disk
d. plastic squares cut from the racket on top of wire mesh
e. 2nd piece of wire mesh
f. covered it with the 2nd plastic disk
g. made another whole in the outer ring to fix sucker
h. connected the wires to 12 volt mobile charger

Thats all. It took about an hour to do all this and the cost is about RS. 150 (120 for charger & 30 for wire mesh).

Lets see the results. The equipment is costing 5500 on one of the onlie sites in India.

Great explanation. I would follow the procedure.